- Laboring Throttle Moan on 2004 - 5.4
-
Junior Member
Laboring Throttle Moan on 2004 - 5.4
If you are experiencing a low pitched intake moan at lower throttle you will fund thus issue to be very simple to repair.
I have an AirRaid cold air intake installed. I purchased my F-150 new in 2004 and installed it the next day.
I removed the intake and the throttle body. 5 bolts for the intake and 4 bolts for the throttle body.
Once the throttle body was in my hand I took this pic.....
20130106_090432.jpg
I used throttle body cleaner and a toothbrush and it came clean very easily....
20130106_092130.jpg
I then removed the MAF sensor and sprayed electrical part cleaner into each slot making sure to focus on thr sensors. DO NOT TOUCH THEM. Once sprayed well blow it dry with air on low pressure.
I put it all back together, connected my negative cable and went for a test drive.
PERFECT.
Good Luck with your repairs.
Steve
-
Chief Moderator
Check u out. Comin in HOT with the how too's. great write up and welcome to the forum.
-
Nice job, I should probably do this for my 05. Welcome to the forum as well too.
-
Junior Member
Thanks guys....glad to find a good forum. I appreciate the welcome...
-
Of course, always glad to welcome another Ford F-150 enthusiast.
-
Chief Moderator
-
Question, you said you disconnected your negative battery cable, was that because you cleaned your MAF, or do you have to do it even when cleaning only the throttle body too? Just curious cause I'm probably gunna do this this weekend along with flushing my transmission and brakes, and installing my programmer lol.
-
-
The Silver Streak
I did mine and didn't disconnect anything but the MAF. Just don't spray urs without disconnecting it.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules