So the trim just pops off? Do you remember what you paid for the new seal
Type: Posts; User: pjohnston
So the trim just pops off? Do you remember what you paid for the new seal
The plastic trim around the window. I want to remove it so I can get to the rubber seal and fix the problem
I have a 2000 f150 xlt ext. Cab. The rear window is the one that slides open. Im having a leak around the window when it rains. Does anyone know how to remove the trim around the outside of the...
Ok. I might have a leak there. Im pretty good at listening for the leaks, thats how i found the one in the 90 and i thought i heard one coming from the back of the motor. I'll check on that tomorrow...
I replaced the 90° elbow awhile back. Where are the IMRC rods and vacuum lines.
----------
U also mentioned a vacuum line in the pax fender. I've never heard of the pax fender. Maybe you can...
It's the aluminum plenum. 171 and 174 are still coming up. Is there any vacuum lines that run on the driver side along the firewall or close to it?
----------
And where are the IMRC rods?
I replaced the pcv valve and hoses. So after all the new parts i still had a mis. For the heck of it, i pulled out the vacuum line in the intake just before the throttle body and sprayed some carb...
When I did mine i didnt mess with the Schrader valve. The line never sprayed, just dropped all over me.
Ill give it a shot and see what happens
My '00 150s fuel filter is on the inside of the frame under the driver door. U will need the special Ford fuel line tool-$5 pepboys. The filter is $10. I put a fram air filter in mine. No oil...
Ye i can tell lol
Raptor05121, so you think that is my problem? You have been the most helpful person and you have responded to all my posts.
----------
Your advice is very much appreciated
Ok that sounds like fun. Wat would cause that clip to break? I think I've adjusted the tilt maybe 5 times since i bought the truck in '01. And y would the clip cause the blinkers to stop working? I...
Thanks i couldn't remember what they were called. I replaced them on my buddy's ranger a few years ago and now its time to do it on my 2000 f150
For awhile when I would use either left or right, it would make a buzzing noise and the light on the dash would go on and off. Now when i turn either on nothing happens. And yes i have the tilt...
Is it the torsion bars on the front that are rattling? It's the part that is a bolt with a steel collar and 4 rubber bushings. If that's not the torsion bars than what are they called? There is 1 on...
I had the plenum off recently to replace fuel injectors. I cleaned it with some carb cleaner but I don't think i got deep enough in it. It was pretty dirty. It's just such a pain with all the vacuum...
Im not trying to go nascar on the truck, just a lil something to help it breathe better. Intake and maybe a good set of exhaust. A few HP and MPG gain for not a lot of money
So if the blue one does the turn signals too, y would the hazards work and not the turn signals
Ok that means i got to get a new plenum gasket
Looking for opinions on cleaning my intake plenum. I've heard seafoam is good but i want some opinions
Anybody know a good intake upgrade that won't cost me a fortune
This is the item in question. I know the blue one is for the hazards
2515
P0171 is usually caused by a vacuum leake. Check all the hoses for holes or lose connections.
----------
171 and 174 are vacuum leaks. Use carb cleaner or wd40 to spray around the intake and...
Looking for early 70s model of any Ford truck.