I am it the process of replacing my
A/C compressor on my 2001 F150 XL. I have the new compressor mounted and at the step to connect the manifold & lines to the compressor.

There are two bolts/nuts on the manifold. One bolt (10mm) comes from the top, through the center of the ports/lines & bolts to the compressor. The second is a bolt (14mm)that is on the side of the manifold block.

My question is there a special sequence to tighten these in? Is there any specific torque requirement? Please let me know. Thanks

Sent from my SM-N950U using Tapatalk