Results 1 to 2 of 2
  1. #1
    Junior Member
    Join Date
    Oct 2018
    Name
    chuck lidderdale
    Location
    colorado
    Posts
    4

    Driver door wiring path

    I need to run 4 new wires from the drivers door to under the dash. So, I can get from the door to the boot between the door and the frame no problem. Once the wiring enters the frame it goes down and from what I can tell (guessing) it comes out behind the parking break mech. Before I start removing he parking break I thought I'd ask - "Am I headed in the right direction? Can I fish a line from the hole in the frame to a hole behind the parking mech.?".

    Thanks

  2. #2
    Junior Member
    Join Date
    Oct 2018
    Name
    chuck lidderdale
    Location
    colorado
    Posts
    4
    Problem solved. The drivers door harness leaves the door, through the boot, in the frame and down. Remove the driver kick panel. The harness comes out behind and below the parking brake mech. in a channel not big enough to feed any new wires through. However next to where it comes out and a little below there is a rectangle rubber plug about 3x4". There is plastic connector holder and a finger to hold the kick plate, 2 screws, remove and un-mount the 2 connectors. From there to the boot is a straight run. So I pulled the boot out of the frame and worked it about half way into the door, fished some string from the rectangle up to the boot, through the boot and pulled my wire through. Then put the boot back and the rec. plug. Then put everything back together.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •