teeje
11-15-2019, 02:13 AM
Hey everyone not new to fords I have a full built 08 mustang GT that I love and recently just got an 06 f150 for the winter. Had the infamous phased knock. No codes no misfiring or stalling..well I replaced the phasers with OEM phasers from ford and it started up just fine. I go for a drive it gets to operating temp just fine I floor it on the highway and bring it to “red line” and it’s fine. I stop at a gas station keep it running go to put it in reverse and it dies. Took it home and it sputtered a few times but stalled almost every time I came to a stop. I unplugged the vct solenoids and drove around and it didn’t stall but the rpms still did go down but not as much. So, to those that have gone through this and I know many have, would you just replace the vct solenoids? It ran fine until it was fully warmed up. After I unplugged the solenoids I shut it off and turned it back on and went back and forth from park to drive multiple times and it only stalled once. Sometimes when going to drive the rpms never dropped but it started to drop again and stall runs fine though other than that. Thanks a bunch. .. 2006 5.4L has new plugs coils are fine, new oem phasers and that’s about it. Single owner truck.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk