joshpickworth
06-21-2014, 11:13 AM
So I wrecked my truck a little over a year and a half ago, hit the drivers side front end into a ditch, they had to do a total frame swap, replaced the rim, lower control arm, strut and bumper, well ever since then my driver side front brake rotor keeps getting warped or burned up, about 3 months after the crash I replaced both front rotors, and put ceramic pads on, couple months later....I tear apart the brakes to find drivers rotor warped, decided to replace caliper, brake rubber line, rotor, and went with the wear ever holds instead of ceramics, few months later....hub bearing goes, same side, replaced it, end up replacicing rotor and pads again!!! I don't know what my next step is, cash is kinda tight but I can't keep throwing rotors at it....I was wondering if the lines weren't bled right at the dealership when they did frame swap could affect it? Could it be an abs issue? Or like a proportion valve??? There's 148??? And I got this truck with 98??? I was even wondering if the caliper mounting bracket could be slightly bent? The steering knuckle? Any input would be greatly appreciated thanks in advance!!!